Untitled Document

‘Electrical’ Category

Electric pump is running on

January 18th, 2009

pump

  • Is the Electric pump switched on and primed. To prime press the prime button on the electric box above the pump, the motor should run and shut off, there should be a small light that will indicate this.
  • Is the gas turned on to the keg coupler? (Perhaps it hasn’t been switched back on after cleaning the lines).Gas is needed to push the beer from the container to the pump, if this isn’t happening the pump will not prime and continue running. This will also cause fobbing problems.
  • Make sure the keg in use is full and the keg coupler is fully depressed.
  • If the motor still runs on contact your local Technical Services.

My beer tap bar lighting isn’t working

January 13th, 2009

lighting_transformer4

Beer dispensers look at their best when lit up.If you find your bar lights are not working you should check the following.

  • Locate the lighting transformers which power the bar lights.These are usually mounted below the bar shelves near to a power outlet
  • Make sure the transformer is switched on at the socket.Quite often people use these sockets for other things and will leave the lighting transformer disconnected.
  • If the power is on, make sure the on off switch, which is mounted on the lighting transformer (this is often missed), is switched to the on position.
  • If your lights are still not working you need to send for your local technician.