| ||||
GET QUOTE
Float keeps dropping in Cellarbuoy
- Make sure the keg is full and the gas is turned on.
- This could be caused by a faulty extractor within the keg. Change the keg,and bleed the fob detector, checking if the glass fills up correctly.
- If it still fills with gas, the problem may lie with the keg connector. Firstly make sure the extractor on the top of the keg is free from dirt or bits of plastic.
- Check that the rubber seal on the bottom of the keg connector is in place and in good condition,free from splits. If your local technician has instructed you on how to change these seals,and left you spares, damaged seals should be replaced.
- If the float in the
Fob Detector
Vent this fob detector
by depressing the top
button, to release the
float the bottom piston
type lever is pushed up
then pulled back so it is
ready for the next
container still keeps dropping contact your local Technical Services.
Important
When using the Inn Doctor site it is important that all relevant Brewery Technical Services regulations and advice and Health and Safety regulations are adhered to. The advice we give does not ask you to interfere, adjust, or in any way tamper with beer dispense or ancillary equipment. Inn Doctor is a means of systematically checking your beer dispense equipment for faults, in accordance with recognised procedures, issued by the major Breweries. You must seek professional advice in relation to any area covered by this website in respect of which you have any doubts whatsoever.
Do not tamper with beer dispense equipment. please read our Disclaimer
